One of most important things while Xbox 360 disassemble controller is utmost care. Be very careful about the process. You have to be delicate with the various small and big parts.

The xbox 360 controller is made up of several parts and these parts are pieces of sophisticated machineries. So you have to be extra careful pertaining to the process of xbox 360 disassembly controller.

Any small miss is detail may cause the whole system to crash. It is advised that if only you are confident about xbox 360 disassemble controller and you take full responsibility of whatever happens then go for it. Or else you can always call for help at the Microsoft.

The materials required for the purpose of xbox 360 disassembly controller are very simple day-to-day use objects. Even the process of disassembly is not very difficult. You need not be a rocket scientist for that matter. If you follow the steps carefully you can easily go about xbox 360 disassemble (disassembly) controller.

You will need, -Flat nose screwdriver no. 0 or no. 1 - two such 2 you might need for the lights and light prying -Philips screwdriver no. 0 or no. 1 - for the Directional Pad -Torx 8 screwdriver no. 8 - The Torx screwdrivers are special ones with holes in the middle -A small container - This container can be used for keeping the small parts such screws, buttons, springs, etc so that you don't lose them

The first important thing is to remove the battery from the back of the controller. Remember this step well as many people forget or completely overlook that the battery needs to be removed before the real xbox 360 disassemble controller begins.

Once the battery is removed you will notice the UPC label code. Carefully remove this sticker so that it can be replaced. And one more thing about the sticker is that once this removed the warranty gets void. So think very carefully that whether you till want to proceed with it or not.

You will have to find 8 screws. Unscrew them and be very careful with the last screw, as some of the parts in the controller are not fixed. These may fall out and you will have no idea where it belongs to.

Once the lower panel is removed the real work pertaining to the xbox 360 disassembly controller begins. Remove the headset plug in device, followed by the left and right control. Pull out the plastic circuit board (PCB) with the processor and microchips carefully. Don't apply too much force or else it might get damaged. Be careful with the wires attached to the PCB. You now have disassembled your controller successfully!

You are currently Not Logged in.
Click here to login or sign up

Subject:  

xComment: